![]() Am I not understanding it right or do these codes apply differently with other models? If I set it to 0x1 it loads like normal, or at least to the factory default that I created and is currently in flash. I've read that 0x2102 is default and is what it should be set at but when I set it to this and do a reload it takes me back into rommon mode again. ![]() ![]() So I had an employee accidently erase flash on a Cisco ASA 5505 and it kept booting to rommon mode because it lost the IOS and had a question regarding the config-register code after re-loading the IOS thru TFTP and saving it to flash.
0 Comments
Leave a Reply. |